A short post telling you its possible to make a fpv / drone remote with the ELRS protocol

The PCB is nothing special, just based of a schematic off a diy elrs board but has easy connectors to connect a arduino nano (Which the Firmware will run on)

The remote shell is WIP

Required Components

• arduino nano: AliExpress Link
• ESP32 Lite: AliExpress Link
• E28-2G4M12S: AliExpress Link
• AMS1117 (3.3v): AliExpress Link
• PCB: oshwlab Link

Note: Some of thease are referral links. If you purchase through it, I earn a commission at no extra cost to you.

Notes:

Want a diy Reciever for ELRS? Look no further than here

Firmware is not by me

The 3d printable joystick is not by me